Tag Archives: broadcom

#! Statler – b43 driver fix.

This week I switched to #! (Crunchbang) because my Ubuntu was getting slow.  I love the speed and was very happy with the wifi because it had the b43 driver working by default.  Except, I could not get on my network after the most recent upgrade, but I found a work-around after a day of reading forums.  Surprisingly, it’s not too complicated!  You just need to create a conf file for b43 to use PIO and it will not through a DMA error anymore… my hardware is: Broadcom Corporation BCM4312 802.11b/g LP-PHY [14e4:4315] (rev 01).  This is the only line you should need.

sudo echo "options b43 pio=0 qos=0" > /etc/modprobe.d/b43.conf

Reference: This article from Ubuntu Forums.

Linux bash script for wifi.

When starting with Backtrack4, I compiled and installed the Broadcom wl driver for my laptop’s wifi. The unfortunate thing was that I got very frustrated because the default connection manager, wicd was getting confused when I would go to a network other than the one I initially connected to after boot-up. Shortly after that, Ubuntu 9.10 was experiencing the same difficulty after upgrading the kernel. So to work around using a network manager, I created a quick script to use.

In this script, you can see that you can pass a variable for your network name and key in the same format as you would normally. This was a fun script as it could easily be adapted as it’s own network manager, even with a little more work, you could have it in the tray, it’s own gui, etc. It’s nothing more than the commands typically used to connect on wifi but it just automated the process. I then went and created a child script for my most used networks, and after placing these in my bin, I actually have started to prefer this method.

Here’s the script:

#!/bin/bash

# die with honor
function usage() {
	echo "usage: ./connectWifi \"<essid>\" [key]"
	echo "       *key in ascii prefaces s:[key]"
	echo
	exit 1
}

# killed in disgrace
function die() {
	echo
	echo "   [*] ERROR: $1..."
	echo
	exit 1
}

# check for essid
if [[ $1 ]]; then
	# setup
	echo "Starting..."
	ifconfig eth1 down
	dhclient -r eth1 -q
	echo " -Previous connection dropped."
	ifconfig eth1 up
	iwconfig eth1 essid "$1"
	echo " -ESSID Set to $1."
	# check for key
	if [[ $2 ]]; then
		iwconfig eth1 key $2
		echo " -Key set to $2."
	fi
	# connect
	iwconfig eth1 mode Managed
	echo " -Connecting..."
	echo
	dhclient eth1
	# announce success
	if [[ $? -eq 0 ]]; then
		echo
		echo "Successfully connected to $1!"
		echo
		exit 0
	fi

else
	# no variables
	usage
fi

# declare failure
die "Failed to connect to $1."

This can serve as a good example of both the commands in connecting to wifi and an introduction to bash scripting. Please comment on the code and offer any suggestions you may have!